Gate Hardware

Old Fashioned Heavy Duty Hinges

• Available in 7", 12", 14", 16", 18", 20", 24", 30", & 36" [see full specs and part numbers]
• Traditional design combined with exceptional strength
• Ideal for gates, barns, garages, garden sheds and carriage houses
• Forged steel straps with heavy duty cast iron cup mounts

What size hinge to use? The rule of thumb for determining the size to use is the band should be about one quarter to one third the width of the gate or door. If the gate or door is over size feet high then a third hinge should be utilized.

Cranked Bands with Pins

Double Strap Hinges

Adjustable Bottom Fitting

Double Strap Hinge Sets

Cane Bolts
Lockable One Piece

Single Strap Hinges

Quick Catch Stainless Steel Latch (Equi Catch)

Recently developed in England the QUICK CATCH is revolutionary in its approach to latching a gate. JUST PUSH THE GATE SHUT AND IT LATCHES One piece stainless steel latch is mounted on a square gate post. A two inch gap is required between the gate and the post. To operate, simply life the bar to free the "U" shaped yoke. Push or pull the gate to open (the yoke will deflect in the direction the gate is opened). To close the gate, push it hard enough to reach the latch. The yoke will engage the edge of the gate and stop it when it reaches the center, holding the gate firmly closed. USED EXTENSIVELY IN THE UK WHERE WHEELCHAIR ACCESS IS REQUIRED.

Chain Eye for Masonry or Stone